文 档: Retrieve the Dynamic CAM Information with SNMP
作 者: Cisco
语 言: 外文
标 签 SNMP Cisco MIB
介 绍:

Before using the information in this document, ensure that you meet the following prerequisites: - Understand how to get VLANs from a Catalyst switch via SNMP - Understand how to use Community String Indexing with SNMP - General use of SNMP get and walk commands

  • The BRIDGE−MIB
  • From the BRIDGE−MIB, which is extracted from RFC 1493 , you can use the dot1dTpFdbAddress from the dot1dTpFdbTable, where the value is equal to 3 or learned, to determine what Media Access Control (MAC) addresses are in the forwarding table on the switch. This value is stored as a unicast MAC address for which the bridge has forwarding and/or filtering information. These MAC address values alone do not mean much and can produce a lot of data. Therefore, you need to count the number of entries and store that count value, based on a dot1dTpFdbStatus (.1.3.6.1.2.1.17.4.3.1.3) equal to learned (value of 3).

Note: The BRIDGE−MIB uses community string indexing to access a particular instance of the MIB as described in SNMP Community String Indexing.

附件下载
相关推荐
Cisco IOS Router Exploitation
Cisco IOS Router Exploitation 来自BlackHat
Retrieve the Dynamic CAM Information with SNMP
Before using the information in this doc
SNMP: 简单网络管理协议
基于TCP/IP的网络管理包含3个组成部分: 1)一个管理信息库MIB(M
SNMP Community String Indexing
This document describes how to use Simpl
阅读心得